15.2.3. Procedure – Configuring PSM to use external indexers

Purpose: 

To configure PSM to accept connections from external indexer services, complete the following steps.

Steps: 

  1. Login to the PSM web interface, and navigate to Basic Settings > Local Services > Indexer service.

  2. Select Indexer service.

  3. Select Enable remote indexing.

    Figure 15.4. Basic Settings > Local Services > Indexer service > Enable remote indexing — Configure external indexers

    Basic Settings > Local Services > Indexer service > Enable remote indexing — Configure external indexers
  4. In the Listening addresses > Address field, select the network interface where PSM should accept external indexer connections. Repeat this step to add other interfaces if needed.

    The available addresses correspond to the interface addresses configured in Basic Settings > Network > Interfaces. Only IPv4 addresses can be selected.

  5. Select Restrict clients, and list the IP address and netmask of your external indexer hosts.

    Use an IPv4 address.

  6. Click Commit.